The sensors are not recognised in Power Meter mode, why is this?

Please confirm the magnets are properly installed, and rotate the crank a minimum of five times.
Check the remaining battery strength in the Sensor Menu. If the Battery Voltage is less than 2.5Volts please replace the batteries.
Open the right side transmitter cover and briefly push the switch inside. The right transmitter LED should flash in Green then both left and right sensor LED should light up for ten seconds in Orange. If these LEDs light up in Green, the sensors are not in Power Mode. Switch to Pedaling Mode by holding the pushswitch down for two seconds. Please see the users manual for details.

Rate this Question/Answer

How well did this answer your question?

0% 25% 50% 75% 100%

If you have any otherfeedback on our FAQs, please provide it here. This form is intended for feedback only. We are unable to respond to questions submitted here. If you have a question or an inquiry, please contact us by Email.

Can't find your answer here? Try our Knowledgebase.